Alloy Fittings Assembly
HOW TO ASSEMBLE AN S-1325 COUPLER LINK |
HOW TO ASSEMBLE A CROSBY CLEVIS TYPE FITTING |
|
1. Slide Coupler Lank over Engineered Flat of Master Link. |
|
1. Place chain link into clevis of chain coupler. Insert pin fullv into the clevis ears. |
|
2. Rotate Coupler Link so that clevis fitting is to the outside of Master Link and attach to chain sling. |
|
2. Place the coupler link on its side and using a hammer, drive the locking pin into the clevis ear until it is flush with the outside surface. |
HOW TO ASSEMBLE A LOK-A-LOY® CONNECTING LINK |
HOW TO ASSEMBLE LOAD PIN IN CROSBY ELIMINATOR FITTINGS |
|
1. Place the locking sleeve between the assembled half link forgings. |
|
1. Place both chain links into clevis slots of fitting, insert pin fully into the two-leg clevis. |
|
2. Drive the pin through the assembled link ends and sleeve until the end of the pin is flush with the outside of the connecting link halves. |
|
2. Place Eliminator assembly on a firm surface. Using a hammer, drive the locking pin into the two-leg clevis until it is flush with the top of the hole. |
| 
