Strona Główna > Produkty > Instrukcje. Ostrzeżenia. Zastosowania > Zestaw zapadki do haka skracającego S-4388

Zestaw zapadki do haka skracającego S-4388

Warning and Application Instructions for Crosby S-4338 Pin Latch

Important Safety Information Read and Follow

•Always inspect hook and pin latch before using.

•Never use a pin latch that is distorted or bent.

•Always make sure internal spring will force the pin latch forward closing throat opening of grab hook. (See Figure 1).

•When a Pin Latch is provided, it is designed to retain loose chain under slack condition.

•Always make sure hook supports the load. The pin latch must never support the load. (See Figure 1, 2, 3 and 4).

•Pin latch is not intended to be an anti-fouling device.

•Recommended for use with Crosby L-1338 or L-1358 Grab Hooks.

Important -Instructions for Assembling

WARNING

•Loads may disengage from hook if proper procedures are not followed.

•A falling load may cause serious injury or death.

•Hook must always support the load. The load must never be supported by the pin latch.

•See OSHA Rule 1926.550(g) A hook and this style latch must not be used for lifting personnel.

•Read and understand these instructions before using hook and pin latch.

Step 1: Using a hammer and the correct roll-pin punch per chart on the right, drive the old latch pin assembly out of hook.

Step 2: Insert new S-4338 pin assembly into hook.

Step 3: Using hammer, tap lightly on latch pin head until guide bushing shoulder touches hook.